Truing a blank with the Router Lathe

The router lathe spins the screw blank between centers while a router slowly traverses from right to left, truing the blank. I made this around 1996 for a PBI class at Penland. It wasn’t motorized then so the students had to crank it by hand. The blank is driven at the headstock by a nailContinue reading “Truing a blank with the Router Lathe”

Free Play of Wooden Screws

This post is in response to Gary’s comment on the November 12 post “Using the Tap”. Yes, an amount of “Free Play” or “Looseness” is important when making wooden screws. One advantage of the thread making method covered in these posts is that the fit of the screw to the threaded hole is adjustable. AContinue reading “Free Play of Wooden Screws”

Making Screw Blanks

The method that I use to make threaded screws requires a precisely made blank. First the blanks are made square; in this case 1-3/4″ x 1-3/4″. Then the corners are sawn off to make them octagonal. After being sawn to length the blanks are rough turned on the wood lathe. The far end of theContinue reading “Making Screw Blanks”

Master Screws

This method of cutting wooden threads depends on master screws. These are used to guide the blanks through the die and establish the pitch of the thread being cut. Above are my three 1″ diameter master screws and two of the brass nuts that are essential for their use. The bottom screw is a ‘doubleContinue reading “Master Screws”

The Die Cutter

In my wooden screw making efforts a “Eureka!” moment was the realization that the thread cutting tool can be made of two rectangular blanks clamped together to form a “vee” cutter. The material is High Speed Steel M2 lathe cutter blanks. The two part cutter is easier to make and easier to sharpen. Here youContinue reading “The Die Cutter”